Adjustments; How To Enter The Service Mode; Product Version; Service Config - Sony KDL-40V4000 Service Manual

3-1. How to enter the Service Mode

Service adjustments to this model can be performed using the
supplied Remote Commander RM-ED013.
1. Turn on the power to the TV set and enter into the stand-by
mode.
2. Press the following sequence of buttons on the Remote
Commander.
i+
5
(ON SCREEN (DIGIT 5)
DISPLAY)
3. The following menu appears on the screen (See Pic.1).
Pic.1
4. Move to the corresponding adjustment item using the
' ' or ' ' arrow buttons on the Remote Commander.
5. Press the ' ' arrow button to enter into the required menu
item.
6. Adjust the data value using the '
on the Remote Commander.
7. To go back at any time press the 'Return' button on the Remote
Commander.
8. Press the 'Menu' button on the Remote Commander to quit
the Service Mode when all adjustments have been completed.
Note :
• To place the Remote Commander in 'Service Mode' press the
following buttons together for two seconds.
i+
(ON SCREEN
DISPLAY)
•
To use the Remote Commander in 'Service Mode' press the
rewind button on the Remote Commander twice.
Rewind
Button
TT will then appear in the bottom right hand corner of the TV.
SECTION 3 ADJUSTMENTS
+
+
I/
TV
(VOLUME +) (TV)
' or ' ' arrow buttons on
+
5
(DIGIT 5) (VOLUME +)
•
To take the Remote Commander out of 'Service Mode' press the
same buttons above together again for two seconds or remove
thebatteries from the Remote Commander.
• After carrying out the service adjustments, to prevent the
customer accessing the 'Service Menu' switch the TV set
OFF and then ON again.

3-2. Product Version

1. The following menu appears on the screen when you enter the
'Product Version' menu (See Pic.2). Be sure to check all pages.
Pic.2

3-3. Service Config

1. The following menu appears on the screen when you enter the
'Service Config' menu (See Pic.3).
Pic.3
(TV)
- 12 -