Connectors - Sony KDL-40V4000 Service Manual

21 Pin Connector (SCART)
21
19
17
15
13
11
9
7
5
3
1
WARNING (UK Models only)
The flexible mains lead is supplied connected to a B.S. 1363 fused
plug having a fuse of the correct rating for the set. Should the fuse
need to be replaced, use a fuse of the same rating approved by ASTA
to BS 1362, ie one that carries the
IF THE PLUG SUPPLIED WITH THIS APPLIANCE IS NOT SUITABLE
FOR THE OUTLET SOCKETS IN YOUR HOME, IT SHOULD BE CUT
OFF AND AN APPROPRIATE PLUG FITTED. THE PLUG SEVERED
FROM THE MAINS LEAD MUST BE DESTROYED AS A PLUG WITH
BARED WIRES IS DANGEROUS IF ENGAGED IN A LIVE SOCKET.
When an alternative type of plug is used, it should be fitted with the
correct rating fuse, otherwise the circuit should be protected by the
same rating fuse at the distribution board.

CONNECTORS

20
18
16
14
12
10
8
6
4
2
UK PLUG WARNING
mark.
T
ASA
Pin No 1 2 Signal
1 Audio output B
(right)
Audio input B
2 (right)
Audio output A
3 (left)
4 Ground (audio)
5 Ground (blue)
6 Audio input A
(left)
7 Blue input
8 Function select
(AV control)
9 Ground (green)
10 AVlink
11 Green
12 Open
13 Ground (red)
14 Ground (blanking)
_ _ Red input
15
_ (S signal Chroma
- -
input)
16 Blanking input
(Ys signal)
17 Ground (video
output)
18 Ground (video
input)
19 Video output
Video input
20
Video input
- -
Y (S signal)
21 Common ground
(plug, shield)
Connected Not Connected (open)
- 6 -
Signal level
Standard level : 0.5V rms
Output impedence : Less than 1kohm*
Standard level : 0.5V rms
Output impedence : More than 10kohm*
Standard level : 0.5V rms
Output impedence : Less than 1kohm*
Standard level : 0.5V rms
Output impedence : More than 10kohm*
0.7 +/- 3dB, 75 ohms positive
High state (9.5-12V) : Part mode
Low state (0-2V) : TV mode
Input impedence : More than 10K ohms
Input capacitance : Less than 2nF
Green signal : 0.7 +/- 3dB, 75 ohms,
positive
0.7 +/- 3dB, 75 ohms, positive
0.3 +/- 3dB, 75 ohms, positive
High state (1-3V) Low state (0-0.4V)
Input impedence : 75 ohms
1V +/- 3dB, 75ohms, positive sync 0.3V
(-3+10dB)
1V +/- 3dB, 75ohms, positive sync 0.3V
(-3+10dB)
1V +/- 3dB, 75ohms, positive sync 0.3V
(-3+10dB)
* at 20Hz - 20kHz
How to replace the fuse.
Open the fuse compartment with
a screwdriver blade and replace
the fuse.
FUSE