Sony KD-75X850xC Reference Manual page 413

Preparing for the installation
of the TV
1
Remove the screws from the
rear of the TV (KD-65X850C
only).
2
Attach the Attachment parts for
Wall-Mount Bracket. Check the
Attachment parts by referring to
"Supplied with SU-WL450" in
"Checking the parts" on page
5.
Note
 Firmly secure the Attachment parts using screws.
 When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
 Be sure to store the unused parts in a safe place for
future use. Retain this manual for future reference.
Standard mounting (2-a)
Belt 
Screw (+PSW 6 x 50) 
Pulley 
Screw
(+PSW 6 x 20) 
Spacer
(60 mm) 
− 9 (GB) −
Slim mounting (2-b)
Note
 You cannot use some of the terminals on the rear of
the TV when using this mounting style.
Belt 
Screw (+PSW 6 x 20) 
3
Connect the necessary cable(s)
to the TV.
Make sure to connect the cables before
installing the TV on the wall. You will be
unable to connect the cables when the TV
is installed.
Refer to the Reference Guide supplied with
your TV.
4
Detach the cable holder
(supplied with the TV).
(KD-55X850C/49X830C/
43X830C only)
Pulley 
Screw
(+PSW 6 x 20)

Spacer (20 mm)

GB