Dishes; Preparing And Maintaining The Wireless Temperature; Sensor - Siemens EX8xxxKYE1E Series Instruction Manual

Dishes

This function can be used to cook a wide variety of
food.The appliance will choose the optimal setting for
you.
Selecting and setting the programme
Select the required cooking zone.
1.
Select the "Dish assistant" type of heating on the
2.
control panel for the cooking zone.
Select the required programme group.
3.
Select the required food.
4.
You will be guided through the entire setting procedure
for the food you have selected, and will be provided
with information on how to cook it.
Cancelling a programme
To cancel a programme, select power setting 0 or
change the type of heating.
Preparing and maintaining the wireless
temperature sensor
In this section, you will find the following information:
s e n s o r e l e s s t e m p e r a t u r e n t a i n i n g t h e w i r P r e p a r i n g a n d m a i
Adhering the silicone patch
■
Using the wireless temperature sensor
■
Cleaning
■
Changing the battery
■
You can obtain a temperature sensor and silicone
patches from specialist retailers or through our
technical after-sales service. Always quote the relevant
reference number.
00577921 Set of 5 silicone patches
HZ39050 Temperature sensor and set of 5 silicone patches
Adhering the silicone patch
The silicone patch attaches the temperature sensor to
the cookware.
A silicone patch must be adhered when using a
saucepan with the cooking functions for the first time.
Proceed as follows:
The adhesion point on the saucepan must be free of
1.
grease. Clean the saucepan, dry it thoroughly and
wipe the adhesion point with a degreasing agent
such as spirit.
Remove the protective film from the silicone patch.
2.
Adhere the silicone patch to the saucepan in the
correct place using the the enclosed template as a
guide.
Press the silicone patch down, including its inside
3.
surface.
The adhesive requires 1 hour to fully harden. The
cookware must not be used or cleaned during this time.
Notes
Cookware with the silicone patch must not be left to
■
soak for long periods in soapy water.
If the silicone patch comes off, attach a new one.
■
Using the wireless temperature sensor
Attach the temperature sensor to the silicone patch and
align it correctly.
Notes
Make sure that the silicone patch is completely dry
■
before attaching the temperature sensor.
Position the cookware in such a way that the
■
temperature sensor is pointing towards the outer
side of the hob.
To prevent overheating, the temperature sensor
■
must not be pointed towards another item of
cookware that is hot.
Remove the temperature sensor from the saucepan
■
after cooking. Store it in a clean, safe place away
from sources of heat.
You can use up to three temperature sensors at the
■
same time.
Cleaning
Do not clean the wireless temperature sensor in the
dishwasher.
You can find information on cleaning the temperature
sensor in the section on ~ "Cleaning"
Changing the battery
If you press the wireless temperature sensor symbol
e r y C h a n g i n g t h e b a t t
and the LED does not light up, the battery is flat.
Changing the battery:
Remove the silicone cover from the lower section of
1.
the casing. Unscrew the screws with a screwdriver.
Cooking assist functions
en
29