2.29. Natpool; Uninitialized_Ippool (Id: 05600001); Removed_Translation_Address (Id: 05600002); Reconf_State_Violation (Id: 05600003) - D-Link DFL-260E Log Reference Manual

2.29. NATPOOL

2.29. NATPOOL
These log messages refer to the NATPOOL (Events related to NAT Pools) category.

2.29.1. uninitialized_ippool (ID: 05600001)

Default Severity
Log Message
Explanation
Gateway Action
Recommended Action
Revision
Parameters

2.29.2. removed_translation_address (ID: 05600002)

Default Severity
Log Message
Explanation
Gateway Action
Recommended Action
Revision
Parameters

2.29.3. reconf_state_violation (ID: 05600003)

Default Severity
Log Message
Explanation
Gateway Action
Recommended Action
ERROR
NATPool <poolname> has not been initialized
The NATPool is not initialized. This can happen if the NATPool
contains no valid IP addresses. If the NATPool is configured to use an
IPPool, no IP addresses have been received form the IPPool.
drop
If the NATPool is configured to use an IPPool, verify that addresses
have been loaded from IPPool.
1
poolname
WARNING
Translation IP address <address> does no longer exist in NATPool
<poolname>
The translation IP has been removed by a configuration change. The
connection is no longer valid and will be closed.
close
None.
1
address
poolname
NOTICE
State violation during
<poolname>.
The NATPool's configuration has changed to STATEFUL. This
connection's translation IP violates the stateful NATPool. Connection
will remain open but will no longer be attached to this NATPool.
decouple
None.
374
Chapter 2. Log Message Reference
re-mapping to STATFUL NATPool