JET USA RX450 Operating Instructions Manual page 11

Remove any adjusting key or wrench before turning the power tool on. A wrench or a key left
d)
attached to a rotating part of the power tool may result in personal injury.
Do not overreach. Keep proper footing and balance at all times. This enables better control of
e)
the power tool in unexpected situations.
Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves
f)
away from moving parts. Loose clothes, jewellery or long hair can be caught in moving parts.
If devices are provided for the connection of dust extraction and collection facilities, ensure
g)
these are connected and properly used. Use of dust collection can reduce dust-related hazards.
4. Power tool use and care
Do not force the power tool. Use the correct power tool for your application. The correct power
a)
tool will do the job better and safer at the rate for which it was designed.
Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be
b)
controlled with the switch is dangerous and must be repaired.
Disconnect the plug from the power source and/or the battery pack from the power tool before
c)
making any adjustments, changing accessories, or storing power tools. Such preventive safety
measures reduce the risk of starting the power tool accidentally.
Store idle power tools out of the reach of children and do not allow persons unfamiliar with the
d)
power tool or these instructions to operate the power tool. Power tools are dangerous in the
hands of untrained users.
Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and
e)
any other condition that may affect the power tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by poorly maintained power tools.
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges
f)
are less likely to bind and are easier to control.
Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking
g)
into account the working conditions and the work to be performed. Use of the power tool for
operations different from those intended could result in a hazardous situation.
5. Service
Have your power tool serviced by a qualified repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.
Notice: Automatic ON/OFF
The motor on this pressure washer does not run continuously. It only runs when the trigger of
the spray gun is squeezed. After following the startup procedures in this manual, turn the
pressure washer ON and squeeze the trigger for activation. See "Operating Instruction" section
in this manual for further details.
WARNING! The electrical supply connection shall be made by a qualified person and comply with
IEC 60364-1. The electric supply to this machine should include either a residual current device that
will interrupt the supply if the leakage current to earth exceeds 30 mA for 30 ms or a device that will
prove the earth circuit.
WARNING! The operating method to be followed in the event of accident (e.g. contact with
detergents: rinse with an abundance of clean water) or breakdown to prevent unsafe situations.
WARNING! The motor of this pressure washer will NOT run unless the trigger is squeezed.
Portable washer safety warnings
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for their
safety.
WARNING!
This product is not intended for pumping water in a home domestic
application. Do not use it for corrosive, abrasive, explosive or dangerous liquids. Fluids
other than water will damage the water pump and/or create a fire hazard.
Last updated 14/02/2014 Version 1.2 11 | P a g e