D-Link DES-1048G User Manual page 29

Contact
1
2
3
4
5
6
7
8
Straight cable for use with MDI-II to MDI-X connections
With a crossover cable, two pairs of wires are switched at one connector end. Carry out
the following steps to create a customized, crossover twisted-pair cable:
1. Leave one end of the cable as is, with the RJ-45 connector intact. The wiring at
just one end of the cable needs to be modified.
2. At the other end of the cable, connect wires 1 and 2 to contacts 3 and 6,
respectively. Likewise, connect wires 3 and 6 to contacts 1 and 2. Refer to the
following diagram:
Crossover cable for use with MDI-X to MDI-X and/or MDI-II to MDI-II connections
DES-1048G Fast Ethernet/Gigabit Ethernet Switch User's Guide
RJ-45 Pin Assignments
MDI-X Port
RD+ (receive)
RD- (receive)
TD+ (transmit)
Not used
Not used
TD- (transmit)
Not used
Not used
The standard RJ-45 pin assignments
MDI-II Port
TD+ (transmit)
TD- (transmit)
RD+ (receive)
Not used
Not used
RD- (receive)
Not used
Not used
21