Feed Dog Height - Janome 415 Servicing Manual

FEED DOG HEIGHT

TO CHECK:
1. LOWER THE PRESSER FOOT.
2. TURN THE HANDWHEEL TOWARD YOU TO BRING THE FEED DOG TO ITS HEIGHEST
POSITION. THE HEIGHT OF THE FEED DOG FROM THE NEEDLE PLATE SHOULD BE
0.75 TO 0.90 MM.
IF IT IS NOT IN THE RANGE, ADJUST AS FOLLOWS.
ADJUSTMENT PROCEDURE:
1. REMOVE THE BASE (SEE PAGE 5).
2. LOWER THE PRESSER FOOT AND TURN THE HANDWHEEL TOWARD YOU UNTIL THE
FEED DOG COMES TO ITS HIGHEST POINT.
3. LOOSEN THE SCREW (A) .
4. TURN THE FEED LIFTING PIN TO ADJUST THE HEIGHT OF FEED DOG (0.75–0.90 MM).
5. TIGHTEN THE SCREW (A).
6. TURN THE HANDWHEEL TOWARD YOU TO RECHECK THE HEIGHT OF FEED DOG.
7. ATTACH THE BASE.
NEEDLE PLATE
MECHANICAL ADJUSTMENT
0.75 TO 0.90MM
FEED LIFTING PIN
14
(A)