Makita PM7650HG Instruction Manual page 21

3. Mount another supplied nozzle with a small discharge hole.
NOTE: Choose a right nozzle out of the following two according to the kind
(viscosity) of the chemical you use.
Nozzle type
Aluminum nozzle (silver color) (7) *
Brass nozzle (gold color) (8) *
Brass nozzle with punch marking
2
(gold color) (9) *
Note 1: The discharge rate shown in the table is that in case of water only used for a guide line. This varies by chemicals being used.
Note 2: The type of the nozzle(s) provided with the mist blower changes from country to country.
4. Mount the top nozzle (3) and secure it with the screw (1).
Note: When using an above small-amount-solution-discharge nozzle, do not mount
the dispersion cover (4) and put it aside so that it is not lost.
5. Set the knob (10) to the position 4.
7. TRANSPORTING THE MIST BLOWER
Please keep the mist blower in an upright position whenever transporting or storing.
(Refer to the figure.)
Transporting or storing in a position that is not upright may cause oil to spill inside
the mist blower engine. This may result in oil leaks and white smoke from burning
oil, and the air cleaner may become dirty with oil.
DANGER:
When transporting and storing the mist blower, be sure to stop the engine.
Viscosity of chemical
2
High
2
Low
Low
Example of chemical
MALATHION (Mix the oil.)
Aqua K-Othrine (Mix the water.)
Cipermetrinato (Mix the water.)
21
(7) (8)
(9)
Discharge rate (L/min)* 1
0.14
0.075
0.060
(3)
(10)