How To Drain The Internal Water Tank - Soleus Air PMC-12HP-201 Operating Instructions Manual

MAINTENANCE
*You will need a small pan, approximately 1" high to catch the water coming out of the water tank. Once
the water tank is empty, the unit will resume operation within a few minutes.
1. Do not move the unit when the water container is full. (Water will spill out)
2. Place a small pan under the condensation drain hole on the bottom side of the unit.
3. Remove the drain plug from the condensation drain hole. The condensate water will drain out automati-
cally.
4. When the drain pan is full, install the drain plug back onto the condensation drain hole to stop the water
flow.
5. Empty the drain pan.
6. Repeat steps 2-5 until all the water is emptied.
NOTE: Once the condensate tank has been emptied, fir mly pr ess the dr ain plug back onto the con-
densation drain hole (Fig 16.1). It is not advised to use continuous drainage when the room temperature is
higher than 90˚F.
NOTE: You may also use enclosed Optional Dr ain Tube to facilitate the dr aining pr ocess, make sur e
to re-plug the Drain Stopper once the condensation tank has been emptied (Fig 16.2).

HOW TO DRAIN THE INTERNAL WATER TANK

Fig 16.1
Fig 16.2