Technicolor COM2000 Integrator's Manual page 49

4 = Fixed - In this mode the user sets the Base_IP, Subnet and Gateway fields. All fields MUST
be set. A Gateway MUST be defined regardless of it being there or not for this mode. Once you
set the card IP you must reboot the card.
8 = No Change - This setting does not actually represent a separate mode, but rather acts as a way
to tell the COM46 card that you would like it to continue using whatever mode it is currently
using. For example, you could use this selection to tell a card that is already using Fixed mode that
you want it to start using a different IP address by selecting this option and entering a different
value into the "Base_IP" field.
 Base_IP - In the Default mode this field will display the IP address of the card. In the
DHCP_Persistent mode this field will display the last address stored in non-volatile memory.
In the Fixed mode this field is where you would enter the IP address you wish to assign to that
card.
 Subnet - This field allows you to give a subnet mask of your choosing to the COM46 card.
This field is only applied in the Fixed mode.
 Gateway - This field allows you to set a default gateway of your choosing for the COM46
card. This field is only applied in the Fixed mode and must be set when using that mode.
 Time-to-Live - Time to Live field in IP protocol header.
 Log_IP - This field allows you to direct the COM46 card to send its log files to an external
destination automatically. This is very useful for monitoring the health of the system over an
extended period. After entering the IP address of the destination, the log files will start being
forwarded to this address after a short delay. You may then run a system-logging utility like
Kiwi on the destination computer to capture this information. Once the Log IP is set you must
reboot the card.
 Log_Level - This field allows you to define the level of detail that will be captured in the
resulting log files. Due to the complexity of this setting, it is strongly advised that it be left
blank unless someone from support has asked to change the value.
 UtilConfig - This field is for development purposes only, and should be left blank unless you
have been asked to modify the value by someone from technical support.
w w w . t e c h n i c o l o r . c o m / m c s Page 49