Optional Orbi Add-On Satellite Leds; Connect Your Router - NETGEAR Orbi User Manual

Optional Orbi Add-On Satellite LEDs

You can purchase add-on Orbi satellites (sold separately) and add them to your Orbi network.
Table 2. Orbi Add-On Satellite LED description
LED
Power
Add-On Satellite ring

Connect Your Router

To cable your router:

1. Unplug your modem's power, leaving the modem connected to the wall jack for your
Internet service.
If your modem uses a battery backup, remove the battery.
2. Plug in and turn on your modem.
If your modem uses a battery backup, put the battery back in.
Orbi High-Performance AC3000 Tri-band WiFi System
LED Behavior
The Power LED is located above the Power On/Off button on the rear
panel.
• Solid green.Power is on.
• Solid amber. The satellite is rebooting.
• Blinking amber. Resetting to factory default settings.
• Blinking red. The firmware is corrupted.
• Off. Power is not supplied.
Optional Add-On Satellites are sold separately and can be added on to your
Orbi network. The ring LED is located on the top.
• Pulsing white. The satellite is booting.
• Solid white. The satellite is ready to sync to the router (press the Sync
button).
• Blue for 3 minutes. The connection between the satellite and the
router is good.
• Amber for 3 minutes. The connection between the satellite and the
router is fair.
• Magenta. The satellite is not connected to the router or is not getting an
IP address.
• Off. The satellite synced to the router and is working normally.
Overview
10