Installation; Points To Be Considered When Re-Transporting Your Refrigerator; Before Operating Your Refrigerator; Electric Connection - Beko CN159220DX User Manual

3

Installation

B
Please remember that the
manufacturer shall not be held
liable if the information given in the
instruction manual is not observed.
Points to be considered
when re-transporting your
refrigerator
1.Your refrigerator must be emptied and
cleaned prior to any transportation.
2.Shelves, accessories, crisper and
etc. in your refrigerator must be
fastened securely by adhesive tape
against any jolt before repackaging.
3.Packaging must be tied with thick
tapes and strong ropes and the
rules of transportation printed on
the package must be followed.
Please do not forget...
Every recycled material is an
indispensable source for the nature
and for our national resources.
If you wish to contribute to recycling
the packaging materials, you
can get further information
from the environmental bodies
or local authorities.
Before operating your
refrigerator
Before starting to use your refrigerator
check the following:
1.Is the interior of the refrigerator
dry and can the air circulate
freely in the rear of it?
2.Please install the 2 plastic wedges
as illustrated in the figure. Plastic
wedges will provide the required
distance between your refrigerator
and the wall in order to allow the
air circulation. (The illustrated figure
is only an example and does not
match exactly with your product.)
3.Clean the interior of the refrigerator as
recommended in the "Maintenance
and cleaning" section.
4.You will hear a noise as the compressor
starts up. The liquid and gases
sealed within the refrigeration
system may also give rise to noise,
even if the compressor is not
running and this is quite normal.
5.Front edges of the refrigerator
may feel warm. This is normal.
These areas are designed to be
warm to avoid condensation

Electric connection

Connect your product to a grounded
socket which is being protected by a
fuse with the appropriate capacity.
Important:
• The connection must be in compliance
with national regulations.
• The power cable plug must be
easily accessible after installation.
10
EN