Care Recommendations - Wolf E Series Use & Care Manual

OVEN OPERATION
Cooking Modes
WARM
Setting Warm:
Press and turn knob to Warm, then press
1
PLATE WARMING
The oven can be used to warm plates before serving. Place
the wire rack in position 1 and place plates on it. Press
. The warming function will switch off automatically after
12 hours.
Self-Clean
During self-clean, the oven is heated to an extremely high
temperature to burn off food soil. Remove oven rack, oven
pans, rack guides, temperature probe and all other objects.
.
They will discolor if left in during self-clean.
The duration of the self-clean cycle can be adjusted for the
level of cooking residue. For light soil, the duration of the
cleaning cycle is 1.5 hours and 2 hours for heavy soil. The
complete cycle can take up to 5 hours including cool down.
Setting Self-Clean:
Press .
1
Select Self-Clean and press .
2
Turn knob to select desired level of cleaning, then press
3
. Door will lock automatically.
Setting delayed start Self-Clean:
Press .
1
Select Self-Clean and press .
2
Turn knob to select desired level of cleaning, then press
3
.
Turn knob to select desired switch-off time, then press
4
.
To cancel self-clean mode at any time, press
door will lock and remain locked until the self-clean cycle
is complete and the oven temperature has cooled below
300°C. Allow oven to cool completely before removing
residual residue with a damp cloth. Do not use cleaning
agents.

CARE RECOMMENDATIONS

Care Recommendations
OVEN DOOR REMOVAL
To remove, open the oven door completely. Rotate both
hinge latches forward to the open position. Close door to
approximately 30° open, then lift up and out. Refer to the
illustrations below.
To reinstall, insert door hinges into the frame openings.
Open the oven door completely and rotate both hinge
latches back to the closed position.
OPEN
POSITION
CLOSED
POSITION
Oven door hinge latch. Door open 30°.
. The oven
RACK GUIDE REMOVAL
To remove rack guides, push the top of the rack guide
towards the rear of the oven cavity. Tip the top of the guide
in towards the center of the oven and lift the bottom posts
of the guide out of the positioning holes.
To reinstall, insert the bottom posts into the positioning
holes and tip the rack guide up into position. Gently pull the
guide forward until it engages the top holes. Refer to the
illustration below.
RACK
GUIDE
Rack guide removal.
wolfappliance.com
|
9