Led\Voice Status Introduction; Trouble Shooting Guide - X2 Digital Wireless Systems X2-VIDEO-201 User Manual

LED/Voice Status Introduction
1.LED Status
LED turns on
LED turns on
LED turns on
LED flashes
LED flashes
LED flashes
2.Voice Status
"DI" at intervals, it means room number conflicting.
"DI DI" at intervals, it means communication trouble.
"DU", it means the function is not allowed to operate.
Long "DI", it means the unit is powering on.
"DI DI..."and flashes, it means door1 wires broke out.
"DI DI..."and flashes, it means door1 wires broke out.
28
The unit is powering on.
The unit is under mute mode.
The unit is under away mode.
Door1 wires broke out.
Door2 wires broke out
Improper hang up
Problem Possible reason
-Power is not connected.
The unit does not work.
-The unit is OFF.
-The connection between room and door
Cannot call from door station.
station is cut off.
-The unit is OFF.
-The room number has not been setup.
Room station cannot monitor door station. -The connection between room and door
station is short circuit.
-The main unit is OFF.
"DI DI" at intervals when the system connects
-The connection between this unit and the
with more room stations.
main unit is cut off.
"DI DI" continuously when the system
Room number confliction.
connects with more room stations.
-No main unit in the system.
Cannot call from door station, room station
-The main unit is OFF.
cannot monitor door station and sound
"DI DI" at intervals.
Door station can hear the sound from room
Talk volume is too low.
normally, but the room station can only hear
very low sound from door station.
When the system only connects with one
This unit is not the main unit.
room station, it cannot monitor or talk.
Door1 or door2 wires broke out
Sounds "DI DI... " and indicator or
flashes

Trouble Shooting Guide

Solution
-Check if the power is on.
-Refer to Operation 1 "ON/OFF", turn on the unit.
-Check the connection between room and
door station.
-Refer to Operation 1 "ON/OFF", turn on the unit.
-Refer to Operation 10.2 "Room Number
Setup", setup a new room number.
-Check the connection between room and
door station.
-Refer to Operation 1 "ON/OFF", turn on the unit.
-Check the connection between this unit and
the main unit.
-Refer to Operation 10.2 "Room Number Setup",
setup a new room number.
-Refer to Operation 10.2 "Room Number Setup",
reset the unit then setup the room number.
-Refer to Operation 1 "ON/OFF", turn on the unit.
Refer to Operation 7"Talk Volume Adjustment",
adjust the volume.
Refer to Operation 10.2 "Room Number Setup",
reset the unit then setup the room number.
Check the wire connection of outdoor units.
29