Intex 10903 Owner's Manual

(92IO) 48" & 52" 2-SECTIONS POOL LADDER ENGLISH 4.875" X 7.25" 07/17/2006
INTEX ® OWNER'S MANUAL - POOL LADDER
48" (122cm) & 52" (132cm) models
IMPORTANT SAFETY RULES
Read, Understand and Follow All Instructions Carefully Before Installing and Using this Product.
WARNING
• LOCATE THE LADDER ON A SOLID BASE.
• ONE PERSON ON THE LADDER AT A TIME TO PREVENT INJURY.
• THE LADDER SHALL BE INSTALLED PER MANUFACTURER'S INSTRUCTIONS.
• FACE THE LADDER AT ALL TIMES WHEN GETTING IN OR OUT OF POOL.
• REMOVE AND SECURE LADDER WHEN POOL IS NOT OCCUPIED TO PREVENT
UNAUTHORIZED USE AND POSSIBLE DROWNING.
• DO NOT USE THE LADDER FOR ANY PURPOSE OTHER THAN THAT FOR WHICH IT WAS
INTENDED.
• CHECK ALL NUTS AND BOLTS REGULARLY TO ENSURE LADDER STAYS STURDY.
• DURING NIGHTTIME POOL USE, ARTIFICIAL LIGHTING SHALL BE USED TO ILLUMINATE ALL
SAFETY SIGNS, LADDERS, STEPS AND WALKS.
• ALWAYS ENSURE THAT THE LADDER IS USED UNDER CONSTANT ADULT SUPERVISION.
• NO DIVING. NO JUMPING. SHALLOW WATER.
FOLLOW THESE RULES TO AVOID SERIOUS INJURY OR DROWNING
These assembly instructions are the same for the 3-step and 4-step ladders. The assembly drawings show
the 4-step ladder.
Tools required: One (1) Phillips screwdriver
One (1) pair of pliers or a small adjustable wrench
IMPORTANT: Do not fully tighten fasteners until last assembly operation.
1. Leg Installation
Align the groove and notch, connect the "A" upper legs (7) with the "A" lower legs (9), "B" to "B". Turn the
upper leg clockwise to secure.
2. Step Installation
The pool ladder legs have the step mounting fixtures installed at the factory.
With the arrow on the backside of the step mounting fixture facing up, slip the step (6) onto the mounting
fixture, matching the direction of the arrow on the step.
Ensure the back of the step is flush with the mounting fixture, otherwise the step will be installed upside-down.
IMPORTANT: During assembly, the "A" legs fit into the "A" step holes, and "B" legs into "B". Push the
step mounting pins (5) into the holes securing the step in a fixed position.
3. Top platform Installation (One Side at a Time)
Look for the "A" identification mark on the top platform (4). Slide the top platform "A" hole onto the "A" leg, "B"
to "B". Fasten with fasteners (3) as shown.
IMPORTANT: Do not fully tighter fasteners at this time. Follow the illustrations as shown.
4. U-Shaped Top Rail Installation
Install the U-Shaped top rails (1) onto the subassembly as shown and connect with fasteners (2).
IMPORTANT: During assembly, pushing both sides of the ladder inwards will help slide the U-shaped
top rails onto the legs.
5. Final Assembly
Fully tighten all fasteners and apply downward pressure to each step to be sure they are fully anchored in
place. The ladder is now ready to use!
This ladder is designed and manufactured for Intex Pool wall height:
Item # Pool Wall Height
58974 (white & blue) 48" (122 cm)
10903 (silver & white) 48" (122 cm)
58975 (white & blue) 52" (132 cm)
10904 (silver & white) 52" (132 cm)
Refer back of the manual for Parts Reference.
SAVE THE CARTON FOR STORAGE AND THE INSTRUCTIONS FOR RE-ASSEMBLY
92IO
092IO-R0-0707
(92IO) 48" & 52" 2-SECTIONS POOL LADDER ENGLISH 4.875" X 7.25" 07/17/2006
92IO