Transmitter And Receiver Binding - Horizon Hobby blade torrent 110 Instruction Manual

Transmitter and Receiver Binding

To bind or re-bind your quadcopter to your chosen transmitter, follow the directions below.
Binding Procedure
1. Select the correct model in your transmitter.
2. Power off your transmitter.
3. Lower the throttle fully.
4. Power the quadcopter on while pressing
the bind button located on the fl ight control
board below the camera, as shown in the
illustration.
5. Follow the procedures of your specifi c
transmitter to enter Bind Mode.
6. The receiver LED glows solid orange
indicating binding was successful.
If you encounter problems, obey binding instructions and refer to the troubleshooting guide for other
instructions.
If needed, contact the appropriate Horizon Product Support offi ce. For a list of compatible DSM
transmitters, please visit www.bindnfl y.com.
Failsafe
The included receiver does not have failsafe capabilities. Failsafe is detected at the fl ight controller. In
the event of a loss of signal to the receiver the fl ight controller will cut power to the motors to prevent a
fl y-away situation.
9
EN
®