Subscribe to Our Youtube Channel
Related Manuals for Horizon Hobby BLADE ZEYROK BLH7300
Summary of Contents for Horizon Hobby BLADE ZEYROK BLH7300
- Page 1 BLH7300 BLH7360 BLH7380 Instruction Manual Bedienungsanleitung Manuel d’utilisation Manuale di Istruzioni...
- Page 2 NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit horizonhobby.com and click on the support tab for this product. Meaning of Special Language The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: NOTICE: Procedures, which if not properly followed, create a possibility of physical property damage AND a little or no possibility of injury.
-
Page 3: Table Of Contents
Table of Contents Box Contents ..............3 Flying the Zeyrok™ Quadcopter ........11 First Flight Preparation .............4 LED Codes ..............12 Flying Checklist ...............4 Post-Flight Inspection and Maintenance Checklist ..12 Charging Warnings............4 Replacing the Propellers ..........13 Battery Charging ..............4 Drift Calibration..............13 Installing the Transmitter Batteries (RTF) ......5 Troubleshooting Guide ...........14 BNF Transmitter Setup .............5 Exploded View ...............15... -
Page 4: First Flight Preparation
First Flight Preparation Flying Checklist ❏ Always turn the transmitter on fi rst • Remove and inspect contents ❏ Plug the fl ight battery into the lead from the 3-in-1 ESC • Begin charging the fl ight battery ❏ Allow the receiver and ESC to initialize and arm •... -
Page 5: Installing The Transmitter Batteries (Rtf)
Installing the Transmitter Batteries (RTF) Replace the transmitter batteries when the transmitter beeps rapidly. BNF Transmitter Setup Program your transmitter before attempting to bind or fl y If you are programming your DXe using the PC or mobile the quadcopter. Transmitter programming values are shown app, make sure the "Transmitter Channels"... - Page 6 DX6i SETUP LIST ADJUST LIST Model Type Acro TRAVEL ADJ D/R & Expo Channel Travel Chan Sw Pos Expo* REVERSE THRO 100/100 Channel Direction AILE AILE 100/100 THRO ELEV 100/100 AILE ELEV ELEV RUDD 100/100 RUDD GEAR 100/100 RUDD GEAR FLAP 100/100 FLAP...
- Page 7 SYSTEM SETUP FUNCTION LIST Model Type ACRO Servo Setup Chan Travel Reverse Chan Travel Reverse SW Select 100/100 Normal 100/100 Normal Trainer Aux 1 100/100 Normal 100/100 Reverse F Mode Gear 100/100 Normal 100/100 Normal All Others 100/100 Normal D/R & Expo D/R &...
-
Page 8: Installing The Flight Battery
Installing the Flight Battery 1. Lower the throttle stick to the lowest position and center all trims. 2. Set the Flight Mode Switch to Stability Mode (FM0). 3. Power ON the transmitter. 4. Slide the battery into the back of the quadcopter, all of the way forward through the battery loop as shown. -
Page 9: Rtf Transmitter Controls
RTF Transmitter Controls Flight mode switch Camera Control/ Continuous Flip Power LED/ Rate Indicator Dual rate Bind switch switch ON/OFF Switch Adjusting Flight Trims Dual Rate Selection The transmitter beeps each time the trim buttons are The control sensitivity can be changed by pressing and pressed. -
Page 10: Understanding The Primary Flight Controls
Understanding the Primary Flight Controls If you are not familiar with the controls of your quadcopter, take a few minutes to familiarize yourself with them before attempting your fi rst fl ight. Throttle Left Side View Left Side View Descend Climb Throttle up Throttle down... -
Page 11: Camera Controls
3. Attach the camera control board to the landing gear 4. Connect the camera control cable to the quadcopter. The using 3 screws. black, negative terminal should go toward the rear of the quadcopter. Attach the landing gear to the quadcopter using 4 screws. -
Page 12: Led Codes
The quadcopter should not need large trim adjustments. If for any reason the quadcopter loses the transmitter If excessive trim is required to sustain a reasonable hover, signal, the quadcopter will enter a “panic” state. The quad- perform the Drift Calibration. copter will self-level while throttling down for 5 seconds. -
Page 13: Replacing The Propellers
Replacing the Propellers Follow the steps below to replace any damaged propellers: 1. Remove the screw at the base of the propeller and pull the propeller straight up. 2. Note the propellers and the quadcopter are marked “A” or “B” to show the proper location for each propeller, as shown in the illustration. -
Page 14: Troubleshooting Guide
Troubleshooting Guide Problem Possible Cause Solution Quadcopter does not function Flight battery connected with the Replace the 3-in-1 board. Connect the fl ight and smells burnt after connect- wrong polarity battery noting proper polarity ing the flight battery Throttle too high and/or throttle trim Reset controls with the throttle stick is too high and throttle trim at the lowest setting... -
Page 15: Exploded View
Exploded View * Included with BLH7360 only. Optional parts for BLH7300 and BLH7380. Parts Listings Part # Description Part # Description 1 BLH7301 Main Frame 8 BLH7308 Motors (2) 2 BLH7302 Landing Gear (included with BLH7360) Camera w/landing gear 9 BLH7309 (included with BLH7360) 3 BLH7303 Prop Set, Yel, Grn, Blk (6) -
Page 16: Limited Warranty
Product, (iv) attempted service by anyone other Authorization (RMA) number. Pack the Product securely than a Horizon Hobby authorized service center, (v) Product not using a shipping carton. Please note that original boxes may purchased from an authorized Horizon dealer, (vi) Product not... -
Page 17: Warranty And Service Contact Information
Compliance Information for the European Union EU Compliance Statement: Horizon Hobby, LLC hereby declares that this A copy of the EU Declaration of Conformity is available product is in compliance with the essential requirements online at: and other relevant provisions of the R&TTE, EMC, and LVD... - Page 18 ©2016 Horizon Hobby, LLC. Blade, E-fl ite, Zeyrok, SAFE, the SAFE logo, DSM, DSM2, DSMX, the BNF logo, AirWare, ModelMatch and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc.
Need help?
Do you have a question about the BLADE ZEYROK BLH7300 and is the answer not in the manual?
Questions and answers