Connecting Your Camera - Swann NHD-819 Instruction Manual

Connecting your Camera

To connect your camera to the NVR, simply connect the supplied Ethernet cable to the LAN connection on the
camera then plug the other end of the cable (1) into one of the IP camera inputs on the back of the NVR.
DC 48V
It doesn't really matter which input you use as they are quite versatile and will be configured in a later step.
The Ethernet cable is the same at both ends so it doesn't matter which end plugs into the camera or NVR.
Note: The DC Power connector is provided as an alternative power option if required. The NVR will provide PoE
power over the network cable when connected as described above and in this case the DC Power is not needed.
AUDIO
USB
HDMI
OUT
Microphone
DC Power
eSATA
VGA
LAN
Reset
LAN
1 3 5 7
2 4 6 8
1
3