Using Gap Standard Compliance; Installing The Batteries - Philips VOX300 User Manual

Installing and replacing the batteries in the
handset
To insert the batteries, open the battery cover, place the batteries as
indicated and then replace the battery cover. When the battery icon is
blinking, charge is needed. Allow 24 hours for the batteries to fully charge.
On first use it may be necessary to wait for a few minutes before seeing
symbols on the display.
Warning : the base station must always be plugged into the mains
when charging or when in use. Always use rechargeable batteries.
The warranty does not apply to the batteries and any other components
which have a limited lifetime or are exposed to wear.
Warning ! Always use the line cable provided with the product
otherwise you may not have a dialling tone.
Batteries should not be disposed of with general household waste.
Battery life and range
Optimal battery life is reached after 3 cycles of complete charging & discharging. When
reaching the range limit and the conversation becomes crackly, move closer to the base.
To reach optimal range, place the base station away from electrical appliances.
Battery life in talk
time
up to 12 hours

Using GAP standard compliance

The GAP standard guarantees that all DECT
with a minimum operating standard irrespective of their make. Your CD 135 handset and
base station are GAP compliant, which means the minimum guaranteed functions are :
register a handset, take the line, receive a call and dial. The advanced features may not be
available if you use another handset than a CD 135 with your base station.
To register and use your CD 135 handset with a GAP standard base station of a different
make, first follow the procedure described in the manufacturer's instructions, then follow
the procedure described on page 31.

Installing the batteries

Battery life in
standby mode
up to 150 hours
Indoor range
up to 50 metres
TM
GAP handsets and base stations comply
Outdoor range
up to 300 metres
11
EN