Crumpet Button; Defrost Button - Catler 400 series Instructions For Use Manual

2 slice motorised toaster
Hide thumbs Also See for 400 series:
Table of Contents

Advertisement

will cease fl ashing and the A BIT MORE
button surround will cease illumination.
The LED toasting progress indicator will
re-illuminate to the previously selected
browning setting.
4. Once the toasting cycle has finished and
the carriage has risen and locked into the
raised position, the toast ready alert will
sound. Remove the toast. The TOAST/
CANCEL button surround will re-illuminate
in blue for up to 30 seconds, ready for the
next toasting cycle.
A BIT MORE BUTTON CAN BE USED WITH THE
TOAST, CRUMPET AND DEFROST FUNCTIONS.

CRUMPET button

This feature activates additional heat to the
middle heating elements to perfectly toast
crumpet tops and lightly toast the crumpet
bases or to toast the inner side of the cut bagel,
whilst slightly warming the outside of the bagel.
To toast crumpets:
1. Place the crumpets into the toasting slots
with crumpet tops facing inwards as per
the crumpet markings above the middle
elements of the toaster or place the cut
bagel into the toasting slots with cut
sides of the bagel facing inwards as per
the crumpet markings above the middle
elements of the toaster.
2. Select the desired browning setting by
adjusting the browning control slide on the
front of the toaster. The browning settings
range from '1' (lightest) to '5' (darkest).
3. Press the TOAST/CANCEL button and
the surround will illuminate in red and
then press the CRUMPET button and
the surround will illuminate in blue. The
crumpets will automatically lower into the
toasting slots. The middle and side heating
elements will automatically adjust.
4.
The Lift & Look button surround will also
illuminate in blue allowing the toasting
progress to be checked and, if necessary,
cancel the cycle by pressing the TOAST/
CANCEL button when the desired toast
NOTE
colour is achieved.
5. Approximately 10 seconds before the end
of the selected browning setting, the Lift &
Look button will cease illumination. As the
toasting stops and the carriage rises, the
TOAST/CANCEL button surround will fl ash
and the LED toasting progress indicator will
cease fl ashing. The LED toasting progress
indicator will re-illuminate to the previously
selected browning setting.
6. Once the toasting cycle has finished and
the carriage has risen and locked into the
raised position, the toast ready alert will
sound. Remove the crumpets or bagel.
The TOAST/CANCEL button surround will
re-illuminate in blue for up to 30 seconds,
ready for the next toasting cycle. The
CRUMPET button surround will remain
illuminated and should be pressed once to
cancel if a subsequent toasting function is
required. The CRUMPET button surround
will cease to illuminate after 30 seconds or
when the appliance is switched off at the
power point.
PLACE THE CRUMPETS INTO THE TOASTING SLOTS
WITH CRUMPET TOPS FACING INWARDS AS PER
THE CRUMPET MARKINGS ABOVE THE MIDDLE
ELEMENTS OF THE TOASTER OR PLACE THE CUT
BAGEL INTO THE TOASTING SLOTS WITH CUT
SIDES OF THE BAGEL FACING INWARDS AS PER
THE CRUMPET MARKINGS ABOVE THE MIDDLE
ELEMENTS OF THE TOASTER.

DEFROST button

This feature activates additional toasting time
required to toast frozen bread.
To toast frozen bread:
1. Place the bread into the toasting slots.
2. Select the desired browning setting by
adjusting the browning control slide on the
front of the toaster. The browning settings
range from '1' (lightest) to '5' (darkest).
3. Press the TOAST/CANCEL button and the
surround will illuminate in red then press
the DEFROST button and the surround
will illuminate in blue. The bread will
automatically lower into the toasting
slots. The toasting time will automatically
increase.
4. The Lift & Look button surround will
illuminate in blue allowing you to check
on the toasting progress and, if necessary,
cancel the cycle by pressing TOAST/CANCEL
OPERATING YOUR TS 4011 TOASTER
NOTE
9 9

Advertisement

Table of Contents
loading

Related Products for Catler 400 series

This manual is also suitable for:

Ts 4011

Table of Contents