Auto Connection Mode; Connecting Manually; Reconnecting The Bluetooth Phone/Device - Subaru starlink Owner's Manual

4.
Check that "Connected" is displayed next to the
Bluetooth phone/device
complete.
If an error message appears, follow the guidance on
the screen to try again.
NOTE
It may take time if the Bluetooth phone/device connection is
carried out during Bluetooth audio playback.
Depending on the type of Bluetooth phone/device being
connected, it may be necessary to perform additional steps on
the Bluetooth phone/device.

AUTO CONNECTION MODE

Leave the Bluetooth phone/device in a location where the
connection can be established.
When the ignition switch is in the "ACC" or "ON"
position, the system searches for a nearby registered
Bluetooth phone/device.
The system will connect with the registered Bluetooth
phone/device that was last connected, if it is nearby.
when the connection is

CONNECTING MANUALLY

When the auto connection has failed, it is necessary to
connect Bluetooth phones/devices manually.
1.
Press , and then select
2.
Select (Phone).
Phone
3.
Follow the steps
DISCONNECTING Bluetooth PHONE/DEVICE" from

RECONNECTING THE Bluetooth PHONE/DEVICE

If a Bluetooth phone/device is disconnected due to poor
reception from the Bluetooth network when the ignition
switch is turned to the "ACC" or "ON" position, the system
automatically reconnect the Bluetooth phone/device.
If a Bluetooth phone/device is disconnected on
purpose, such as turning it off, this does not happen.
Reconnect the Bluetooth phone/device manually.
Bluetooth ® SETTINGS
(Settings).
Settings
in "CONNECTING OR
59
3 3