Table of Contents
Advertisement
9.2 Safety interlock
The motor/shredding tool may only be
operated when the feed chute has been
properly closed. If the right closure screw
(machine viewed from the front) becomes
loose during operation, the motor is
switched off automatically and after a few
seconds the shredding tool comes to a
standstill.
9.3 Motor run-down brake
The motor run-down brake shortens the
run-down time from when the machine is
switched off until the blades stop to a few
seconds.
9.4 Protective covers
The garden shredder is equipped with
protective covers in the feeding and
ejection areas. These include the
complete feed chute with the upper chute
and splash guard, the ejection chute
extension and the discharge flap.
The protective covers ensure that a safe
distance is maintained from the shredding
blades.
10. Operating the machine
Risk of injury:
Carefully read the section entitled
"For your safety" (
4.) and follow
all the safety instructions before
operating the garden shredder.
0478 201 9906 D - EN
10.1 Electrical connection of garden
shredders
Risk of injury!
Observe the instructions in section
"Warning – dangers caused by
electrical current" (
4.2).
The power cable must be adequately
protected by fuse. (
18.)
Only electric cables which are no lighter
than rubber sheathed cables
H07 RN-F DIN/VDE 0282 may be used.
The minimum cross-section of the power
cable must be 3 x 1.5 mm² for a length of
up to 25 m or 3 x 2.5 mm² for a length of
over 25 m.
The connectors of the electric cable must
be made of rubber or have a rubber cover
and conform to the standard
DIN/VDE 0620.
A CEE plug device and a 5-wire cable
must be used for three phase models.
The plug connections must be splash
proof.
Unsuitable extension cables lead to a loss
of power and may result in damage to the
motor.
GE 150, GE 250, GE 250 S:
This machine is intended for operation with
a power supply having a system
impedance of Z
at the transfer point
max
(house connection) of maximum
0.443 ohms (at 50 Hz).
The user must ensure that the machine is
only operated with a power supply which
meets this requirement.
If necessary, this information can be
obtained from the local electric power
company.
10.2 Connecting the power cable
When choosing a power cable, take
account of all the information in the
"Electrical connection" section
(
10.1).
GE 150, GE 250, GE 250 S:
● Lift clip (1).
● Connect power cable connector.
● Release clip.
GE 260, GE 260 S:
● Connect the power cable connector to
the 5-pin mains plug on the machine.
10.3 Switching on the garden
shredder
There must be no shredding
material in the machine when it is
switched on as it may be expelled.
The blade disc locking device must
always be tilted back to the stop.
(
11.4)
● Connect the power cable. (
● Press the green button (1) on the switch
(illus. shows GE 150, GE 250,
GE 250 S).
The garden shredder starts up.
Only begin to feed the shredding
material once the motor has
reached the maximum speed (idling
speed).
9
10
10.2)
41
Hide quick links:
Advertisement
Table of Contents
