Element And Control Setting; Heating Elements - Haier HCR2250AES User Manual

ELEMENT AND CONTROL SETTING

Turn off all controls when done cooking.
Failure to do so can result in death or re.
The control knobs turn in either direction and from any position to the desired
temperature setting or to OFF.

HEATING ELEMENTS

TEMPERATURE LIMITERS
Each radiant element has its own temperature limiter (sensor) to protect the glass
cooking surface from extreme high temperatures. The temperature limiter operates
automatically by cycling the element to match the heat to the Temperature setting
of the element (HI to LO).
SINGLE RADIANT ELEMENT
This type of electric element uses a wire ribbon located under the glass surface to
provide the heat for cooking. The temperature limiter will cycle the element on and
off.
•
Turn the knob from LO to HI temperature (or any temperature in between).
DUAL RADIANT ELEMENT
The dual element consists of two radiant ribbon elements within the same element.
Either the small (inner element) or both (inner and outer) elements may be selected
for use. There are an infinite number of heat settings between the LO and HI position.
Fixed positions are found at LO and HI to define minimum and maximum heat setting.
To turn ON the inner element, push down on the control knob and turn it
counterclockwise following the single line graphics.
To turn ON both inner and outer elements together, push down on the control
knob and turn clockwise following the double graphics line.
HOT SURFACE INDICATOR LIGHT
Each element features a hot surface indicator light to show when the cooking area is
ON or hot. The signal light will turn on automatically in the area marked with a circle.
The light remains on as long as the surface cooking area is too hot to touch even
after the surface cooking area is turned off.
10
WARNING
Fire Hazard