Advertisement
• Do not press hard against the skin to avoid skin irritation and/or damage to the shaver head.
NOTE: We recommend that you use your new shaver daily for up to four weeks to allow
time for your hair and skin to become accustomed to the new shaving system.
CLEANING AND CARE
CARING FOR YOUR SHAVER:
This shaver is a washable appliance. The head assembly part may be cleaned under
warm water.
NOTE: When cleaning your shaver, make sure the shaver is turned off and disconnected
from the power cord.
CAUTION!
• Shaver can be placed under running water for cleaning only. Never submerge the shaver in
water.
• Never clean the shaver or replace the cutters while it is plugged into an electrical outlet. Do
not remove or replace head assembly while shaver is running as it may cause damage to the
unit's foils and cutters.
• To clean the external surfaces of the shaver, use a damp cloth. Do not use strong detergents
or other chemicals.
• To dry, wipe the surface of the shaver with a dry towel. Do not use a hair dryer or heater to
dry the shaver.
• The shaver should not be used until it has dried.
Cover the shaver foils with the protective head guard between uses. When removing the head
guard or placing it back onto the shaver, do not apply pressure to the foils as you may damage
them.
CLEANING YOUR SHAVER:
Daily Cleaning:
NOTE: We recommend following these steps after each use.
1. Grasp the front and back of the cutter assembly and pull away from the shaver body.
(Diagram G)
2. Tap the stubble from the foils and cutters.
3. Use the cleaning brush to sweep any loose hairs from the cutters and trimmer. Rinse them in
cold or warm water. DO NOT use hot water. DO NOT submerge the shaver in water. (Diagram
H & I)
4. After cleaning, replace the hair pocket assembly. (Diagram J)
5
Advertisement
