Table of Contents
Advertisement
Welcome Center
The Welcome Center allows you to create or open Whiteboard files, Bridgit software conferences,
and computer and video source sessions, as well as open the Unifi 35 Settings dialog box to
configure the firmware (see page 9) and end the current session (see page 74).
The Welcome Center appears when you start a firmware session. If you're in a Whiteboard file,
Bridgit software conference, or computer or video source session, open the Welcome Center by
pressing Menu in the toolbar.
Shortcut Menu
The shortcut menu allows you to move between Whiteboard files, Bridgit software conferences,
and computer and video source sessions without opening the Welcome Center.
The currently open
session is outlined
in yellow.
NOTE: A session only displays in the shortcut menu if you select its input's Add a button for this
input in the shortcut menu check box (see page 18 and page 20).
To open the shortcut menu, press
move to that session, or press outside of the shortcut menu to close it.
46
The LinQ/Bridgit dialog box only
displays if there are open
Bridgit software conferences or
LinQ software connections.
to the right of Menu in the toolbar. Press a session's button to
Using the Firmware
Advertisement
Table of Contents
Need help?
Do you have a question about the SMART Board600i Series and is the answer not in the manual?