Getting Started - Schlage PIM400-TD2 User Manual

The following is an overview of the steps required to set up the PIM400-TD2:
1. Install the WAPM (AD-400, WPR400, etc). See the installation guide that came with the
WAPM or visit www.allegion.com/us (see Support>Schlage Electronics>Electronic Locks
Technical Library) for more information.
2. Make sure the PIM400-TD2 is located to allow for optimum RF signal transmission.
See Determine the location on page 6 for more information.
3. Before installing the PIM400-TD2, check for proper communication function and linking
with WAPM(s). See Pre-installation test on page 6 for more information.
4. The PIM400-TD2 has been evaluated for UL compliance in indoor applications only.
5. Make sure to follow unique installation procedures if installing on an indoor metallic
wall. Refer to Mount the PIM400-TD2 on page 7 for more information. Consult the
Schlage Utility Software (SUS) user guide for information about configuring the
PIM400-TD2 and the WAPM.
6. Familiarize yourself with the information contained in this user guide.
This user guide is for the PIM400-TD2 only.
Save this user guide for future reference.
4 • Schlage • PIM400-TD2 user guide

Getting started