Advertisement
Playing the analog program source
Press
the button for the program source to be played.
EX1: CD
. Press the button once to switch the source to DAT/TAPE in-
put, again to cancel DAT/TAPE input.
2
Select the ANALOG input mode.
ANALOG
/DIGITAL
ANALOG/DITAL
:\
::
—
Lights
Check that the "ANALOG" indicator is lit.
3
Start playback on the selected component.
For operating instructions, refer to the various components'
manuals.
4
Adjust the MASTER VOLUME control.
III
I
II
The volume is indicated
on the set's display.
BASS
TREBLE
Turn the control clockwise to increase the bass or treble, coun
terclockwise to decrease it.
6
If the indicator lights when the
"
OVER LOAD" LED is lit, press
the ATTENUATOR button.
. The input level is lowered by —6 dB.
Notes: • For digital input sources, there is no need to adjust the
ATTENUATOR.
lThis button will not operate.)
• If the indicator does not turn off when this button is
pressed, adjust the output level on the player.
• This button cannot be used when playing in the
6—channel EXT.IN mode.
:
rr
EO
ERCU
f1I+-O
"
4
NGCR1[&
BASTER VOLUME
MASTER VOL.
I
cD
I
IDATrrAPE MoNt
.
EX2: DAT/TAPE
DAT/TAPE MON
• The volume can be adjusted in units of 1 dB from —6Oto 0
to +18dB.
5
Adjust the BASS and TREBLE.
ATTENUATOR
ERROR!
OVERj LOAD
4o
Light
25
Advertisement
