Dell PowerConnect 6024 Getting Started Manual page 12

1
If you enter [N], the Setup Wizard exits. If there is no response within 60 seconds, the
Setup Wizard automatically exits and the CLI console prompt appears. If you enter [Y], the Setup
Wizard provides interactive guidance throughout the initial device configuration.
NOTE:
If there is no response within 60 seconds, and there is a BootP server on the network, an address
is retrieved from the BootP server.
NOTE:
You can exit the Setup Wizard at any time by entering [ctrl+z].
Wizard Step 1
If you enter [Y] the following information appears:
The system is not setup for SNMP management by default. To
manage the switch using SNMP (required for Dell Network
Manager) you can:
• Setup the initial SNMP version 2 account now.
• Return later and setup the SNMP version 2 account. (For more
information on setting up a SNMP version 2 account, see the
user documentation).
Would you like to setup the SNMP management interface now?
(Y/N)[Y]
1
Enter [N] to skip to Step 2 or enter [Y] to continue the Setup Wizard. If you enter [Y] the
following information appears:
To setup the SNMP management account you must specify the
management system IP address and the "community string" or
password that the particular management system uses to access
the switch. The wizard automatically assigns the highest access
level [Privilege Level 15] to this account. You can use Dell
Network Manager or other management interfaces to change this
setting later, and to add additional management system later.
For more information on adding management systems, see the user
documentation.
To add a management station:
Please enter the SNMP community string to be
used:[Dell_NetWork_Manager]
2
Enter the following: User SNMP community string, for example "MYSETUPWIZARD".
3
Press Enter.
10
Getting Started Guide