Yamaha DISKLAVIER ENSPIRE User Manual page 33

Speakers
Symptom
The audio from the speakers is
not in sync with the video (audio
is delayed).
The audio from the speakers is
not in sync with the piano
playback (audio is delayed).
No sound is heard from the
speakers.
The speaker volume is too low.
No video sound is heard from the
speakers connected to the
OUTPUT jacks.
The left channel sound is heard
more than once or seems to have
an echo.
No sound is heard from the
speakers.
The speaker volume is too low.
Hissing sound is coming from the
speakers.
Remedy
See page 25 on adjusting the delay.
Check the audio delay specifications of the speakers.
See page 25 on adjusting the delay.
Check the audio delay specifications of the speakers.
Make sure that the speakers are turned on.
Make sure that the audio cable is firmly connected to the speaker.
Make sure that the audio cable is not disconnected.
Make sure that the speaker volume is adequately turned up.
Make sure that the volume of the desired input is turned up.
Make sure that you are using the audio cable without impedance
changer.
See page 22 on adjusting audio balance.
See page 22 on adjusting main volume.
It is possible that you have the DisklavierTV website opened more than
once. Make sure that ONLY the DisklavierTV website is opened.
Reboot your computer.
Make sure that the audio volume of computer is adequately turned up.
Make sure that the audio cable is correctly connected to the audio input
jack.
Make sure that the USB audio driver is correctly installed on your
computer.
Make sure that USB audio is selected in the audio device setting on
your computer.
Make sure that the USB audio output volume is adequately turned up.
Make sure that the audio volume of computer is adequately turned up.
Make sure that you are using the audio cable without impedance
changer.
Replace the audio cable.
In case you are using a USB audio interface, make sure that the USB
audio output volume is adequately turned up.
Make sure that the surround system on your computer is TURNED
OFF. Audio enhancements prevent DisklavierTV from working properly.
Reverse the left and right connection, and then check the sound is
appropriately output from the speakers.
Replace the audio cable.
Make sure that you are using a stereo audio cable.
Troubleshooting
DisklavierTV User's Guide (For Disklavier ENSPIRE Users)
33