Setting The Crossover Frequency Individually For The Different Channels; Selecting The Surround Speakers For The Different Surround Modes - Denon AVR-3806 Operating Instructions Manual

ENGLISH
Advanced Setup – Part 2
• If "LFE+Main" is set at "Subwoofer Setup", "SW:LFE+Main"
( page 74) is displayed at the top right of the screen.
• We recommend using with the crossover frequency set to "80
Hz", but depending on the speaker, setting it to a different
frequency may improve frequency response near the crossover
frequency.
• The crossover frequency mode is valid only when subwoofer is
set to ON, and when one or more speakers are set to SMALL,
as described in section "Speaker Configuration" settings (
page 73).
Setting the crossover frequency individually
for the different channels
1
CURSOR F F
Press the or
"Advanced" at "Crossover Frequency" screen.
2
CURSOR D D or H H button to select the
Press the
speaker to be set.
3
Press the
frequency.
4
Press the
• The "Speaker Setup" menu reappears.
• If "LFE" is selected at "Subwoofer Setup", the frequencies
can only be selected for speakers set to "Small" at "Speaker
Configuration".
G G
button to select
• If "LFE+Main" is set at "Subwoofer Setup", the frequencies
can be selected regardless of the speaker size setting.
Selecting the Surround Speakers for the
different surround modes
• This menu is displayed when both surround speakers A and B
are used.
• At this screen preset the surround speakers to be used in each
surround modes.
1
Press the
"Surround Sp Setup" at "Speaker Setup" menu,
then press the
• The "Surround Sp Setup" screen appears.
CURSOR F F G G
or button to select the
ENTER
button to enter the setting.
CURSOR D D H H
or button to select
ENTER
button.
77
ENGLISH
Advanced Setup – Part 2
2
CURSOR D D or H H button to select the
Press the
surround mode, then press the
button to select the surround speaker.
A:
When surround speakers A is used.
B:
When surround speakers B is used.
A + B:
When both surround speakers A and B are used.
3
ENTER
Press the button to enter the setting.
• The "Speaker Setup" menu reappears.
4
CURSOR
Press the D D or H H button to select
ENTER
"Exit", then press the button.
• The "System Setup Menu" reappears.
• For the "WIDE SCREEN" and "7CH STEREO" DSP simulation
modes, the surround speakers can be set separately.
2 About Speaker type setting when using both
surround speakers A and B
If "Small" is set for either surround speakers A or B, the output
is the same as when "Small" is set for both A and B.
CURSOR
F F or G G