Receiver Installation - Nyrius NPCS600 Instruction Manual

RECEIVER INSTALLATION

Receiver
• Connect the HDMI cable to the HDMI Output of the Receiver and to your HDTV
television or HD projector.
• Ensure your TV or projector is powered ON and is in "HDMI input" mode.
• Connect the power adapter to the DC Input of the Receiver and plug into a wall
outlet. When the unit is successfully connected, the Power LED indicator on the
POWER button lights up in WHITE.
• Once the Transmitter and Receiver are both connected, they will automatically pair
to each other.
• When you disconnect the Transmitter and the link is disconnected over 10 minutes,
the Receiver will enter STANDBY MODE (Power LED of the Receiver is Orange)
• When the Transmitter is reconnected the Receiver will automatically wake and
reconnect. During the warm-up period, the POWER LED will flash WHITE until
the signal between the Transmitter and the Receiver is established. It will take
approximately 15 ~ 20 seconds to boot-up and establish a link providing everything
is operating normally.
• If all is operating normally, the LEDs will be SOLID WHITE and setup will be
complete.
Note: Obstacles may decrease transmission distance. Interference may come from
other wireless devices using 5GHz band.
For maximum performance, please use the included power adapters.
RCA
VIDEO 1
HDMI
CABLE
COMPONENT
HDTV
6