Amplicomms bigtel 50 alarm plus User Manual page 74

Starting/Ending the automatic emergency call
The phone behaves as follows on starting the automatic emergency call:
1. The emergency phone loudspeaker is switched on. An acoustic "emergency
call active" signal is sounded for 15 sec.
2. You can then hear the dialling tone and the phone numbers assigned to the
M1, M2 and M3 buttons are automatically dialled, in succession, at intervals
of approx. 60 seconds. The outgoing alert message is played in a continu-
ous cycle.
3. The person answering the call immediately hears this alert message. The
person taking the call stops the outgoing alert message by pressing "0".
You can then converse for 3 minutes. Handsfree mode remains active on the
phone making the emergency call during this time.
4. When the 3 minutes have elapsed, the call is disconnected. An attempt
begins again to dial the phone numbers assigned to buttons M1, M2 and
M3 as described above.
5. If the call is disconnected or the receiver is placed on-hook before the 3
minutes have elapsed, an attempt is made to dial the emergency numbers.
The emergency procedure won't be stop unless 3 numbers have been dia-
led out or press the button on the emergency call unit again or press M1,
M2 or M3 for 5 seconds.
Note: To end an emergency call, press the button on the emergency call unit
again or press M1, M2 or M3 for 5 seconds.
Helpline UK 0844 800 6503
(See page 79 for costs and hours of operation)
T
T B P
ELEFON EINSTELLEN
ELEFON IN HONE SETTINGS ETRIEB NEHMEN
71