(1)
17.9 mm (1600P-DB/DBX)
17.5 mm (1600P)
17.9 mm
(2)
(3)
5. Feed Cam Timing
To Check:
[1] Lower the needle bar by turning the handwheel until
[2] The feed dogs should not move when moving the
To Adjust:
[1] Remove the base and lay the machine on its back.
17.5 mm
[2] Lower the needle bar until the needle point is 17.9
A
[3] Loosen the setscrews (2).
[4] Tighten the setscrews (2) and attach the base.
B
4
the point of the needle is 17.9 mm (for 1600P-DB/
DBX) or 17.5 mm (for 1600P) above the upper
surface of the needle plate (1).
reverse stitch lever up and down.
If the feed dogs move, adjust the feed cam timing as
follows.
mm (for 1600P-DB/DBX) or 17.5 mm (for 1600P)
above the needle plate (1).
(Use the third step from the right for 17.9 mm or the
marking for 17.5 mm on the Gauge 767G-001).
While moving the reverse stitch lever, turn the feed
cam (3) in the direction either A or B until the feed
dogs stop moving.