Needle Threader (1600P Only) - Janome 1600P Servicing Manual

(3)
(2)
(1)
(1)
(2)
(2)
(4)
(1)
(4)
(3)
(6)
(5)

15. Needle Threader (1600P only)

To remove:
[1] Remove the face plate.
[2] Pull the threader (1) out from the threader shaft (2).
To attach:
[3] Align the groove (3) of the theader with the pin (4) on
the threader shaft. Push the threader up until it snaps
in place.
To adjust:
[1] If the threader hook (1) thrusts or hits against either
left or right edge of the needle eye (2):
Loosen the setscrew (3). Move the threader plate (4)
to adjust the lateral position of the threader hook (1).
[2] If the threader hook (1) thrusts or hits against either
top or bottom edge of the needle eye (2), or misses
the needle eye (2):
Loosen the setscrew (5). Move the threader position
setting plate (6) up or down to adjust the vertical
position of the threader hook (1).
12