Mounting The Cvr100W; Back Panel; Placement Tips - Cisco CVR100W Quick Start Manual

Back Panel

WAN The WAN (Internet) port is connected to your Internet device, such
as a cable or DSL modem.
LAN (1-4) These ports provide a LAN connection to network devices, such as
PCs, print servers, or switches.
RESET The RESET button has two functions:
•
•
12VDC This port is where you connect the power adapter (12 V/0.5 A).
POWER Press this button to power the CVR100W on and off.
Do-Not-
•
Disturb
Mode
•
Light
•

Mounting the CVR100W

2
You can place your CVR100W on a desktop or mount it on a wall.

Placement Tips

• Ambient Temperature—To prevent the CVR100W from overheating,
do not operate it in an area that exceeds an ambient temperature of
104°F (40°C).
• Air Flow—Be sure that there is adequate air flow around the CVR100W.
• Mechanical Loading—Be sure that the CVR100W is level and stable to
avoid any hazardous conditions.
Place the CVR100W on a flat surface so that it sits on its four rubber feet.
4
Reboot: Press the RESET button for at least 1 but no more than
5 seconds with a pencil tip to reboot the unit.
Reset to Factory Defaults: Press and hold the RESET button for
more than 5 seconds to reboot the unit and restore the factory
defaults. Changes that you have previously made to the
CVR100W settings are lost.
Solid green when the Do-Not-Disturb Mode button on the front
panel is turned on and the CVR100W is operating normally.
Flashes green when the Do-Not-Disturb Mode button is turned
on but the Internet connection has problems.
Off when the Do-Not-Disturb Mode button is turned off.
Cisco CVR100W Wireless-N VPN Router Quick Start Guide