Advertisement
JH-8013/JH8014 Manual
JH-8013/JH8014 Manual
please face to the microphone of your mobile phone.
It's better that connect your
B. Product parts
mobile phone to LINE-IN socket of the receiver by the wired headphone cable.
This function will only be suitable for the mobile phone that its network is
more than 2G.
Or use the receiver as a bluetooth earphone of your mobile phone.
6. Computer chatting instruction
(1) Plug the external microphone cable into the MIC socket of a computer and
clip the microphone on to your lapel close to your mouth.
(2) Connect one end of the wired headphone cable into the LINE-IN socket of the
receiver, and the other end into the headphone socket of the computer.
Ensure
Model A
Model B
the volume on the receiver is set to the lowest
, then switch it on, adjust the
(for one receiver)
(for two receivers)
VOLume, TONE, BALance to your required levels.
、
1 Transmitter
Note: the speaker volume of the computer may need to be adjusted properly.
、
2 Receiver
6.
�
�
、
、
3 Audio cable1
4 Audio cable2
7. Charging instruction
、
5 Optical fiber cable
(for JH-8014A/B)
Switch off the receiver, and remain the transmitter on during charging.
There are two charging ways.
(1) Charging the receiver:
Place the receiver into the charging bay of the transmitter. The receiver can
only fit into the bay if its indicator faces the indicator of the transmitter.
、
、
6
Microphone
cable
7 Wired headphone cable
(2) Charging the battery in the charging compartment:
Open the battery case of the receiver, pull out the Li-ion battery. Insert it into
the charging compartment at the side of the transmitter as shown below.
05
14
Advertisement
