Intelligent Steam Control - Shark S3973 Series Owner's Manual

Intelligent Steam Control

The Shark Lift-Away
® ®
the right amount of steam for the cleaning task at hand. See below for tips on when to use each setting.
SETTING
Laminate
DUST
Hardwood
LIGHT STEAM
Marble
Hardwood
MOP
Marble
Tile
NORMAL STEAM
Stone
Hardwood
SCRUB
Marble
Tile
HEAVY STEAM
Stone
For an extra burst of steam, you can use the Steam Blaster feature in DUST, MOP, or SCRUB.
Steam Blaster
™
Follow the instructions found on the "Using your Steam Pocket Mop" page.
TO SANITIZE* WITH THE STEAM MOP USING THE INTELLI-MOP
1
Attach a clean Dirt Grip pad to the mop head.
2 Plug in the unit and press the Steam Control Button to select the SCRUB Setting.
3
Wait 30 seconds for the unit to begin producing steam.
4
Start mopping on an appropriate sealed hard floor surface with a forward and backward motion. After three minutes,
your unit is ready to be used to sanitize.
5
Using a forward and backward motion, move the unit over the area you seek to sanitize. Repeat at least 15 times.
* Sanitization studies were conducted under controlled test conditions. Household conditions and results may vary.
With the Intelli-mop head only in SCRUB mode. Not in above floor mode or when using Steam Blaster.
9 1-800-798-7398
®
Pro Steam Pocket Mop has 3 unique Intelligent Steam Control settings so you can use
®
IDEAL FOR THESE SEALED
SURFACES
RECOMMENDED USAGE
Cleaning delicate surfaces
Light cleaning and dusting
Loosening and lifting light dirt
Cleaning most surfaces and large areas
Basic, everyday cleaning
Removing spots and smaller messes
Cleaning moderate and heavy-traffic areas
Deep-cleaning and cleaning hard-to-clean surfaces
Tough cleaning and removing stuck-on messes and stains
Deep-cleaning heavy-traffic areas
Cutting through heavy dirt and grime
Sanitizing* floors
HEAD AND THE DIRT GRIP
™
PAD:
™