Installation & Setup; Monitor; Camera - TECHVIEW QC-3762 User Manual

Installation & Setup:

Monitor:

1. Pull out the folding stand to position the monitor securely.
2. Position the antenna located at the top of the monitor to an upright position.
3. Connect the 5VDC,2A mains power adaptor to a 240VAC standard power outlet, and
the DC plug in to the power socket of the monitor.
4. Press and hold the power/scan button located on the top of the monitor for 3-4
seconds for the unit to power up.
5. The monitor will display the TECHview startup screen for a few seconds and will
transition to live view.
Please Note: The screen will remain dark until the cameras are powered up.

Camera:

1. Position the camera securely in place, it is best to have the monitor located near the
camera temporarily so you can see the exact position of the camera.
2. Once you have camera in the correct position, mark the location of the screw holes.
3. An extra hole may need to be placed for the power cable to run depending on your
installation.
4. Fix the included screws and anchors to attach the camera to the wall or ceiling.
5. Attach the wireless antenna to the rear antenna socket and screw in tightly.
6. Connect the 9VDC, 600mA mains power adaptor to a 240VAC standard power
outlet, and the DC plug in to the power socket of the camera.
7. Once the camera and monitor are powered on, the unit now should be displaying
the camera footage.
Please Note: Please install the camera in an undercover area if place outside as the unit
is weatherproof only.