Initial Settings; Adjusting Initial Settings; Setting The Clock; Switching The Warning Tone - Pioneer DEH-P7700MP Operation Manual

Section
12

Initial Settings

Adjusting initial settings

Initial settings lets you perform initial setup of
different settings for this unit.
1 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press Multi-Control and hold until the
clock appears in the display.
3 Turn Multi-Control to select one of the
initial settings.
Turn Multi-Control clockwise to switch be
tween the functions in the following order:
Clock (clock)Warning tone (warning tone)
AUX (auxiliary input)Dimmer (dimmer)
Brightness (brightness)SW control (rear
output and subwoofer controller)Mute (tele
phone muting/attenuation)Demonstration
(feature demo)Reverse mode (reverse
mode)Ever-scroll (ever scroll)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.

Setting the clock

Use these instructions to set the clock.
1 Use Multi-Control to select Clock.
Clock appears in the display.
54
En
1
2 Push Multi-Control left or right to select
the segment of the clock display you wish
to set.
Pushing Multi-Control left or right will select
one segment of the clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3 Push Multi-Control up or down to set
the clock.
Pushing Multi-Control up will increase the
selected hour or minute. Pushing
Multi-Control down will decrease the se
lected hour or minute.
Notes
! You can match the clock to a time signal by
pressing Multi-Control.
 If the minute is 0029, the minutes are
rounded down. (e.g., 10:18 becomes
10:00.)
 If the minute is 3059, the minutes are
rounded up. (e.g., 10:36 becomes 11:00.)
! Even when the sources are off, the clock dis
play appears on the display.

Switching the warning tone

If the front panel is not detached from the
head unit within four seconds of turning off
the ignition, a warning tone will sound. You
can turn off the warning tone.
1 Use Multi-Control to select
Warning tone.
Warning tone appears in the display.