Section 20: Start-Up Procedures - Weather-Rite XT112 Installation, Operation & Service Manual

SECTION 20: START-UP PROCEDURES

Electrical Shock Hazard
Disconnect electric before service.
More than one disconnect switch may be
required to disconnect electric from
equipment.
Equipment must be properly grounded.
Failure to follow these instructions can result in death, electrical shock or injury.
Explosion Hazard
Leak test all compo-
nents of equipment
gas piping before
operation.
Gas can leak if
piping is not
installed properly.
Do not high pressure
test gas piping with
equipment
connected.
Failure to follow these instructions can result in death, injury or property damage.
DANGER
WARNING
Carbon Monoxide
Hazard
Do not recirculate air
from the heated
space over burner.
Air supply to burner
must be from outside.
Severe Injury Hazard
Do not enter equipment while in operation.
Equipment may start automatically.
Do not operate with door open.
Installation, operation and service must be
done by a trained technician only.
Falling Hazard
Use proper safety
equipment and
practices to avoid
falling.
Do not use any part
of equipment as
support.
SECTION 20: S - P
TART UP ROCEDURES
Burn Hazard
Allow equipment to
cool before service.
Internal components
of equipment may
still be hot after
operation.
61