Table of Contents
Advertisement
S
XT I
, O
S
M
ERIES
NSTALLATION
PERATION AND
ERVICE
ANUAL
FIGURE 13: Inlet Hood
Roof
Left Panel
Right
Panel
Rain
Gutter X2
Bottom
For an air handler supplied with a filter section a single hood is provided. For an air handler with inlet hood
mounted filters, two hoods are provided. To install inlet hood on an exterior wall, drill holes 8" (20.3 cm) in the
flanges of the inlet hood and mount with lag bolts (provided by others).
The following hardware is supplied for the assembly of the inlet hoods; #10 TEK self tapping screws, 3/8"
nuts/bolts/washers, 3/16" rivets and foam gasket tape.
Step 11.2 Inlet Hoods with Filter Rack Assembly
Step 11.2.1 Seal around the perimeter of the inlet of the air handler with the provided foam gasket tape.
Step 11.2.2 Mount the upper inlet hood right and left side (flanges will be facing out), with the bolts and wash-
ers provided.
24
Advertisement
Table of Contents
