Table of Contents
Advertisement
Available languages
Available languages
2.
GETTING STARTED
2.1 Powering up
IMPORTANT: Before turning on the Cassida C200, make certain no coins are
present in the coin hopper. This will cause an "EA" error when the C200 self-test
is performed. To clear the "EA" error, press the "START/STOP" button, then empty
any coins present in the coin trays.
Turn on the power switch located on the rear of the unit. The machine will
conduct a self-check. The main display will show "0" when the test has successfully
completed.
2.2 Counting
The C200 always operates in a batching mode. To enable simple counting, all
batch quantities need to be set to zero. To set batch quantities to zero, press
and hold the "-" button for approximately three seconds until "C" is displayed on
the left of the LED display.
•
Before loading the hopper, make sure there are no uncounted coins
remaining in it from the previous count.
•
To count coins, place them into the hopper and press the "START/STOP"
button.
•
The C200 will start counting and will automatically sort all coins into the
appropriate coin trays.
•
The machine will automatically stop when all coins in the hopper are
counted, or if the batch quantity for any coin denomination is reached.
•
To stop the machine, press the "START/STOP" button.
10
•
To resume counting, press the "START/STOP" button.
•
When a coin tray becomes full, stop the machine and empty the tray to ensure
correct machine operation. Stopping the machine will not alter or reset the
count. You can continue counting by pressing the "START/STOP" button.
•
As it counts, the Cassida C200 will automatically display the total value of
counted coins on the screen.
•
To view the value of coins counted for each denomination press the "REPORT"
button. The denomination will appear on the left and value of coins counted
on the right part of the screen. To display the number of coins counted, press
the "+" button.
While in the REPORT mode, pressing the "+" button will switch the display
between value of coins counted or number of coins counted. The C200 will
remember the last setting chosen for the report display.
•
To reset the coin count before starting a new batch, press the
"C" button.
2.3 Adding
The C200 operates in ADD mode by default. In ADD mode, the coin count is added
to the count from previous batches. To start a new count, press the "C" button. This
will reset the coin count to zero.
2.4 Setting Batch Quantities
You may batch the desired quantity of each coin denomination.
denomination can be assigned a batch quantity.
Cassida C200 coin counter/sorter/wrapper
Each
11
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
