Table of Contents
Advertisement
Installation
– Scope of delivery: dryer, installation and instruction manual, jug, basket for woollens
(depending on the model).
– Check dryer for transport damage.
– The dryer is heavy. Do not attempt to lift it on your own.
– Be careful to avoid sharp edges.
– Do not install in a room where there is a risk of freezing. Freezing water may cause damage.
– If in doubt, have the appliance connected by a specialist.
– Do not lift the dryer by protruding parts (e.g. the door) - risk of breakage.
Setting up the dryer
1.
– The appliance plug must always be accessible.
– Ensure that the appliance is installed on a clean, level
and firm surface.
– Keep the cooling grille on the front of the dryer
clear.
– Keep the area around the dryer clean.
– Level the dryer using the threaded feet.
Use a spirit level.
– Do not remove the threaded feet under any
circumstances.
Do not install the dryer behind a door or sliding
door, which could prevent or restrict opening of the
dryer door. This will prevent children from locking
themselves in and putting their lives in danger.
Mains connection
2.
see safety information
– Connect to an AC earthed socket. If in doubt, have the socket checked by a specialist.
– The mains voltage and the voltage shown on the rating plate (
– The connected load and necessary fuse protection are specified on the rating plate.
Converting the installed load
3.
10/16 Amps
1 x to the
Press and hold selection
turn to
then turn 3 x to the right
right
Off
10 A
Feedback
16 A
Frost protection / Transport
Preparation
1. Empty the condensation container
2. Select any programme using the programme selector.
3. Press the
start button
condensation is pumped into the container.
4. Wait 5 min., and then empty the condensation container again.
5. Turn the programme selector to Off.
The water tank must not contain any distilled water. If necessary, run the Steam/Refresh programme.
Remove all accessories
from the drum.
The drum must be empty.
Clean and level
Make sure that the air inlet
remains unobstructed
page 13.
Page 11) must be the same.
Note the fuse protection of the socket.
Set
amperage
Do not operate the dryer if there
is a danger of frost.
page 4.
Technical data
Dimensions (DxWxH)
Weight
Max. capacity
Condensation container
Water tank
Connection voltage
Connected load
Fuse protection
Ambient temperature
Product number
Production number
The rating plate can be found on the back of the dryer.
Drum interior light
The drum lights up after the door is opened or closed, and after the programme starts,
and switches off automatically. Changing the bulb
Consumption rates
Fabrics/programmes
Cottons 8 kg
Cupboard Dry*
Iron Dry*
Easy-Care 3.5 kg
Cupboard Dry*
* Programme setting for testing in accordance with applicable standard EN61121.
** The values may differ from those specified, depending on the type of fabric, composition of
laundry to be dried, residual moisture in the fabric and the amount of laundry being loaded.
Fabrics/programmes
Cottons 8 kg / 4 kg*
Cupboard Dry ***
***Programme setting for testing and energy labelling in accordance with Directive 2010/30/EU.
turn to
Off
Optional accessories
Platform
WZ
20500
For easier loading and unloading. The basket contained in the drawer can be used to carry
the laundry.
WZ
Washer-dryer stack connection set
20310
The dryer can be placed on top of a suitable washing machine with the same width and depth
to save space. The dryer must be fastened to the washing machine using this connection set.
With pull-out worktop: WZ 20300
Connection fittings for condensation outlet
WZ
20160
The condensation is conveyed directly via a hose.
WZ
Installation underneath the worktop
20290
Instead of the appliance covering plate, you must have a metal cover fitted by a specialist.
10
60 x 60 x 85 cm (adjustable height)
approximately 43.5 kg
8 kg
4.0 l
approx. 0.4 l
220-240 V
max. 2800 W
16 A / 10 A
5 - 35 °C
Inside of door
(bulb E14, 25 W)
(depending on model)
page 12.
(The value on the label is achieved at the maximum heat setting.)
Residual moisture in the
Drying time**
fabrics after spinning
10 A
16 A
1400 U/min
(50%)
137 min
111 min
1000 U/min
(60%)
155 min
129 min
800 U/min
(70%)
173 min
147 min
1400 U/min
(50%)
114 min
88 min
1000 U/min
(60%)
132 min
106 min
800 U/min
(70%)
150 min
124 min
1000 U/min
45 min
39 min
800 U/min
(40%)
48 min
42 min
600 U/min
(50%)
60 min
51 min
Drying time
98 min / per cycle
(from after-sales service using order number, depending on the model)
Energy consumption**
10 A
16 A
4.01 kWh
4.01 kWh
4.82 kWh
4.82 kWh
5.55 kWh
5.55 kWh
2.40 kWh
2.40 kWh
3.69 kWh
3.69 kWh
4.14 kWh
4.14 kWh
1.05 kWh
1.05 kWh
1.35 kWh
1.35 kWh
1.65 kWh
1.65 kWh
Annual energy consumption
581 kWh / per year
11
Advertisement
Table of Contents
