Table of Contents
Advertisement
Chapter 6 Monitoring and Diagnostics
If the underrun is also associated with the Rx L|M=100 alarm, check the status of
the remote DATA interface (not the clocking interface). To do so, do the
following:
1. Go to Monitoring>Physical layer>Port>E1.
If LOS or AIS are increasing, the attached PW will not be sending traffic to the
remote unit.
2. In case of LOS, continue using the Physical Link failure procedure.
3. In case of AIS, check the connected equipment for the reason it is generating
AIS towards the ACE unit.
Rx Congestions
This may occur if the buffer located between the PW packets towards the ATM
has overflowed.
Note
The Rx Congestion dropped counter represents the number of packets dropped
due to congestion on the receive direction, i.e. from the PSN side to the ATM
direction.(Packet Delay Variation) Buffer is used to compensate for PDV in PSN
networks.
To check the Rx Congestion counter for amount and frequency of dropped
packets:
•
Go to Monitoring>Applications>Multiservice over PSN>PW>Statistics.
RX congestion dropped
Possible causes:
•
ATM BW issues
•
Insufficient PSN ATM buffer size
•
Shaping problems
•
Bursty traffic coming from the remote device.
ATM Bandwidth issues
Check that the ATM attachment circuit related to the PW is providing the
expected amount of bandwidth:
IMA
Check the number of E1 links belonging to the IMA group:
1. Go to Configuration>Applications>ATM>IMA.
6-106
Recovering ACE Units
LOS
... (0
LOF
... (0)
LCV
... (0)
LCD
... (0)
RAI
... (0)
AIS
... (0)
Installation and Operation Manual
FEBE
BES
DM
ES
SES
UAS
Rx frame slips
... (0)
ACE-3105, ACE-3205 Ver. 5.2
... (0)
... (0)
... (0)
... (0)
... (0)
... (0)
... (0)
Advertisement
Table of Contents
