Troubleshooting - Ace -3205 Installation And Operation Manual

Installation and Operation Manual
Diagnostics> Applications> IP> Trace Route
1. Destination IP address
2. Start
>
Please select item <1 to 2>
ESC-previous menu; !-main menu; &-exit
Parameter
Destination IP
address
Start/Stop
Note
Only one route tracing session is allowed at a time.
6.5
The following troubleshooting chart is based on LED indications or other inputs.
Use this chart to identify the cause of a problem that may arise during operation.
For detailed description of the LED indicators functions, refer to
To correct the reported problem, perform the suggested remedy actions. If a
problem cannot be resolved by performing the suggested action, please contact
RAD technical support (see
Fault/Problem
The unit is "dead"
(POWER LED is off)
The unit is "dead"
(POWER LED is off)
ACE-3105, ACE-3205 Ver. 5.2
ACE-3205 – RAD Data Communications
Figure 6-68. Trace Route Menu
Table 6-66. Trace Route Options
Description
Specify the destination IP address towards
which the trace-route packets are to be
sent
Activates the route tracing towards the
specified IP address.
To stop the tracing, re-select this option or
exit the Trace Route menu.

Troubleshooting

Section 6.8
Table 6-67. Troubleshooting Chart
Probable Cause
No power
Blown fuse
Chapter 6 Monitoring and Diagnostics
... (100.10.151.201)
Possible Values
0.0.0.0–
255.255.255.255
Default: 0.0.0.0
).
Remedy Action
Check that both ends of the power
cable are properly connected.
Disconnect the power cable from
both ends and replace the fuse with
another fuse of proper rating.
Troubleshooting
Chapter 3
.
6-81