Sony KP-41 EXR96 Operating Instructions Manual page 15

!
t;orlnecTlng ulner I:qulpment
After maltingthese connections, y ou willbe able to do the following: =
• View the playbackof videotapes • RecordTV 15rograms • Recordone "IV program whileviewinganother program
: Signal flow
to S video input
YC-15V/30V
(not supplied)to _
S video
output
d
(Rear of projection TV)
IN OUT
to audio input
RK-74A
(not supplied)
to
audio
output
VCR, video disc player, etc.
I
to VHF/UHF output
to VIHF/UHF
Y%
_z
_w
€-,,I
"E"
Preparing for use
1
Tun3on the projection TV.
2
Set S-VIDEO to "ON" (p. 48).
3
PressTVNIDEO on the projectionTV or on the Remote
Commandersothat =VIDEO 1"appearson the screen.
To return to TV mode
PressTV/VIDEO or CHANNEL +/- on the projection TV,
or pres_ W/VIDEO, CH +/- or 0 - 9 and ENTER on the
Remote Commanderso that a ohannel numberappears
on the screen.
Note
You can watch both a TV and a VCR image at once, using
Picture-in-Picture (pp, 40 - 43).
Operating the equipment
To operate the video equipment, refer to the instruction
manual that comes with the equipmen'E.
You can operate a Sony VCR or video disc player, or
a non-Sony VCR with the supplied Remote Commancler.
For details, see "Using the Pre-Programmed Remote
Commander" (pp. 66- 72).
About S video input
Video input and output signals can be separated intoY
(luminanceor brightness)and C (chronna or color)signals.
Usuallythese two signalsare combinedin a VCR and sent
as one signal to a projection IV. Separationof the Y and C
signalspreventsthem from interfering with one another,
thereby improvingpicture(especiallycolor)quality.
This projection"IV is equippedwith S videoinputjacks
throughwhichthese separated signals; c an be inputdlirectly.
Chapter 1: Setting Up
115