Important Safeguards; Special Instructions; For Your Safety - T-Fal FV32xx series Instructions Manual

NOT FV32XX FTC 036635

IMPORTANT SAFEGUARDS

When using your flatiron, basic safety precautions should always be followed, including the following:
11.1Use iron only for its intended use.
12.1To protect against a risk of electric shock, do not immerse the iron or the base of the iron in water
or other liquids.
13.1The iron should always be turned OFF before plugging or unplugging from outlet. Never yank cord
to disconnect from outlet ; instead, grasp plug and pull to disconnect.
14.1Do not allow
putting away. Loop cord loosely around iron when storing.
15.1Always disconnect
emptying and when not in use.
16.1Do not operate iron with a damaged cord or if the iron has been dropped or
damaged. To avoid the risk of electric shock, do not disassemble the iron. Contact our Consumer
Service Department for examination, repair or adjustment. Incorrect reassembly can cause a risk
of electric shock when the iron is used.
17.1Close supervision
children. Do not leave iron unattended while connected or on an ironing board.
18.1Burns can
caution when you turn a steam iron upside down - there may be hot water in the reservoir.
19.1This appliance is only for domestic and personal use.
11.1To avoid a circuit overload, do not operate another high-wattage appliance on the same circuit.
12.1If an extension cord is absolutely necessary, a 13 ampere cord should be used. Cords rated for less
amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or
tripped over.

For your safety

• This appliance complies with the technical rules and standards for safety currently in force
(Electromagnetic Compatibility, Low Voltage, Environnement).
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
• Warning ! The voltage of your electrical outlet must correspond to that of the iron (120V). Connecting to
the wrong voltage may cause irreversible damage to the iron and will invalidate the guarantee.
• If the electrical cord becomes damaged, it must be immediately replaced by an Approved Service Center
to avoid any danger.
• The appliance should not be used if it has fallen, if it has obvious damage, if it leaks or has functional anomalies.
2
5/12/06 11:39
Read all instructions before using the iron.
cord to touch
iron from electrical
is necessary
occur from touching

SPECIAL INSTRUCTIONS

SAVE THESE INSTRUCTIONS
Page 2
hot surfaces. Let iron
outlet when
for any appliance
hot metal parts,
cool completely before
filling with water
being used by or
hot water or steam. Use
or
near