Seiko 8B92 Instructions Manual page 30

Troubles
When the watch is unable
to receive a radio signal
Reception
of a radio
The reception results have
signal
failed and the second hand
points to N (the watch does
not receive a radio signal).
The stopped watch was
exposed to an adequate
light for longer than
Charging
"the time required to
the solar fully charge the watch,"
however, it does not
battery
resume its normal
one-second interval
movements.
58
8B92_E_42-66.indd 58-59
Possible causes
The watch was moved while it was receiving a
radio signal.
The watch was left where the radio signal was weak
or where it was unable to receive a radio signal.
Transmitting stations may have stopped
transmitting radio signals for some reason
(Transmission stop).
The stopwatch 1/5-second and minute hands
are not reset.
The watch is set to a time zone other than
receiving range.
The amount of exposed light is too weak.
The time for charging the watch is not
sufficient.
The built-in IC of the watch has fallen into an
unstable condition.
Solutions
Do not move the watch while it is receiving a radio signal.
Because it takes time to receive a radio signal successfully, leave the watch untouched
for 12 minutes at the longest.
Place the watch where it is able to easily receive a radio signal.
Check the website of each transmitting station for further information concerning a
transmission stop. Attempt to receive a radio signal again after a while.
Reset the stopwatch 1/5-second and minute hands.
① Check the time zone that the watch is currently set for, and select the time zone.
② When the watch is not displaying the precise time, receive a radio signal again if necessary.
The time required for charging the watch depends entirely on the amount of exposed
light the watch receives.
Refer to "GUIDELINE OF CHARGING TIME" to charge the watch.
Refer to "IMPROPER FUNCTION" to reset the built-in IC.
59
2016/04/27 15:55