Contec BX710 Series User Manual page 93

4. BIOS Setup
EISA configuration checksum error
[PLEASE RUN EISA CONFIGURATION UTILITY]
The EISA non-volatile RAM checksum is incorrect or cannot correctly read the EISA slot. This can
indicate either the EISA non-volatile memory has become corrupt or the slot has been configured
incorrectly. Also be sure the card is in-stalled firmly in the slot.
EISA configuration is incomplete
[PLEASE RUN EISA CONFIGURATION UTILITY]
The slot configuration information stored in the EISA non-volatile memory is incomplete.
CAUTION
When either of these errors appear, the system will boot in ISA mode, which allows you to run the
EISA Configuration Utility.
Error encountered initializing hard drive
Hard drive cannot be initialized. Be sure the adapter is installed correctly and all cables are correctly
and firmly attached. Also be sure the correct hard drive type is selected in Setup.
Error initializing hard disk controller
Cannot initialize controller. Make sure the cord is correctly and firmly installed in the bus. Be sure the
correct hard drive type is selected in Setup. Also check to see if any jumper needs to be set correctly on
the hard drive.
EISA configuration invalid
[PLEASE RUN EISA CONFIGURATION UTILITY]
The non-volatile memory containing EISA configuration information was programmed incorrectly or has
become corrupt. Re-run EISA configuration utility to correctly program the memory.
CAUTION
When either of these errors appear, the system will boot in ISA mode, which allows you to run the
EISA Configuration Utility.
86
BX710 series User's Manual